Getting Started
Switching on the Unit
Before switching on the unit, check that:
-
The installation of the unit is complete.
-
The computer is switched on.
 |
IMPORTANT: You must switch on the computer and wait for it to be ready to receive the connection before switching on the unit. |
To switch on the unit, follow these steps:
-
On the unit column, press the ON button.
-
Switch on the unit and wait for a minute for the connection between the unit and the CS 9600 workstation or the practitioner computer to be established.
If you have an imaging software and you started it before the connection was established, the following window will display to tell you that you must wait before you start using the imaging software:
