Using the CS 9600 Unit > Acquiring 2D Sinus Images
Before acquiring an image, check that you have:
Selected the patient record.
Accessed the Imaging window.
Accessed the Acquisition interface.
Selected the correct positioning accessory.
Positioned the patient correctly.
To acquire an image:
Leave the x-ray room and close the door. You must keep visual contact with the patient during acquisition.
Important: To stop the acquisition in an emergency, release the exposure button on the remote control or press the red emergency stop button.
Launch the x-ray with the remote control. Press and hold the exposure button until the end of acquisition. The Ready Indicator turns yellow, indicating x-ray transmission. The accessory position detector turns blue.
When the acquisition ends, the Acquisition interface disappears, and the image is transferred to the Imaging window.
Check the image quality. If you are satisfied, click Validate; if you are not satisfied, click Discard and take the x-ray again.
When the acquisition is complete:
Open the temple supports and release the patient from the unit.
Remove the hygiene barrier from the bite block and any accessories that were used.
Reset the unit rotative arm for the next acquisition.