Moving and Tilting the Oblique Coronal Slice Plane in the MPR Tab
In the Trace View Screen, the oblique coronal slice plane has two handles, (A) and (B) at each end that allow you to move and tilt the slice plane in the Trace View Screen and 3D View Screen.
In the MPR tab, you can tilt the plane of the Coronal Slice View Screen (also referred to as the cross-section or trans-axial view screen).
This allows you to align the plane with anatomical features in the 3D volume.
In the Trace View Screen, do any of the following:
-
To move the plane of the oblique coronal slice along the trace, click and drag a blue handle (A).
-
To tilt the plane of the oblique coronal slice, click and drag the round handle (B).
|
|
Note:
|
