Template Preferences

In the Template preferences, you can do the following:

Select print templates to use with Film Composer.

Note: You need Film Composer installed on your computer for this action.

Select a view screen layout for the MPR tab. See “Using the MPR Tab”.
Select the number of columns used to display slice series on the Review tab. See “Using the Review Tab”.

To set the Template options, follow these steps:

In the Main Toolbar Icons, click .

The Preferences window appears.

In the Preferences window, click .

The Template preferences appear.

Do any of the following.

To select the print template you want to use for each workspace tab and maximized view screen...	In the Print templates section, select from the relevant dropdown list the templates that will be used when you print images using Film Composer. Note: You must restart CS 3D Imaging for this setting to take effect. This section only appears if Film Composer is installed on your computer.
To select the default layout for the MPR tab...	In the Layout for orthogonal slicing section, click one of the Template for orthogonal slicing icons. The position of the blue square determines the position of the 3D View Screen on the MPR tab.
To select the default number of columns displayed on the Review tab...	In the Review default column count section, select a number from the dropdown list.
To reset the preferences to the installation defaults...	Click .

Warning!

Film Composer templates fit images within placement frames as either “Best Fit” or 1:1. Therefore the dimensions of a printed image can vary depending on the template used.

4. Click Apply.