Making Measurements

 

You can take measurements on 2D MPR images by using the tools described in this section.

 

Warning!

  • The CS 3D Imaging Software cannot manage your device's acquisition settings. It is the role of the acquisition device to provide calibrated data.

  • Drawings and measurements made in the software are done under the responsibility of the user.

 

Note:

  • When you draw an object on an image, the behavior of the object depends on the view:

    • When you draw an object on a 2D MPR image in the MPR tab, it “floats” above the image, so that when you slide the view through different slices the object remains visible at all times.

    • When you draw an object on a slice on the Review tab, the drawing object is attached to that specific slice, so if you view a different slice the object disappears.

  • To cancel a drawing operation, press the ESC key.

  • Units of measurement are Standard International (SI) units: millimeters (mm) for length, cubic centimeters (cm3) for volumes, and degrees (°) for angles.

 

Related Topics

 

The Exchange

Need more information?

Connect with us on The Exchange!