Switching On the Unit
Before switching on the unit, check that:
-
The installation of the unit is complete.
-
The computer is switched on.
-
The imaging software is not opened.
 |
IMPORTANT: You must switch on the computer and wait for it to be ready for the connection before switching on the unit. |
To switch on the unit, follow these steps:
-
On the unit column, press the ON button.
-
You must wait for a minute for the connection between the unit and the computer to be established. If you start the imaging software before the connection is established, an error message is displayed. Click OK, close the imaging software, and wait for the connection to be established.
-
Start the CS Imaging Software.
Increasing the Operating Life of the X-Ray Tube
