Setting Up CS 3D Imaging Preferences
In the Application preferences, you can do the following:
Choose whether MAR volume should be displayed by default or not.
Switch between the Easy and Advanced modes (Dental and ENT only).
Select the workspace tab you want to see every time you open the software.
Activate/deactivate previews of images being loaded by CS 3D Imaging.
To set the Application preferences, follow these steps:
In the Main Toolbar Icons, click .
The Preferences window appears.
In the Preferences window, click .
The Application preferences appear.
Do any of the following.
To switch between the Easy and Advanced modes...
|
To display fewer tools in the tool box, click Easy. To display all available tools in the tool box, click Advanced. Note: This setting only applies to Dental and ENT versions of the software because the Imaging Center version can only be run in Advanced Mode.
|
To display available MAR data by default...
|
Next to When available, display MAR volume by default, click Yes. Click No, always display FDK to display FDK reconstructions by default.
|
To select the default workspace tab that should appear when you launch CS 3D Imaging... |
Click one of the following:
|
To configure the preview of a volume while the complete volume is being loaded... |
To deactivate this feature and have no preview volume, deselect View preview version of a volume while the complete volume is loading.
To activate this feature and have a preview volume, indicated by the label in the upper corner of the image, select Show a preview version of the volume while it is loading.
|
To reset the preferences to the installation defaults... |
Click .
|
Click Apply.